Use a photoelectric-FET optocoupler as a linear voltage-controlled potentiometer 
Use a photoelectric-FET optocoupler as a linear voltage-controlled potentiometer
http://www.edn.com/design/analog/436889 ... entiometer

[ 1 comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
Writing and then Reading from Flash Memory on msp430g2553 
Writing and then Reading from Flash Memory on msp430g2553

http://e2e.ti.com/support/microcontroll ... 91331.aspx

[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
Rotary Encoder Tutorial with Arduino Code 


[ add comment ] ( 1 view )   |  [ 0 trackbacks ]   |  permalink
Inspiration for a design 
http://www.synthtopia.com/content/2011/ ... ontroller/
http://www.gforcesoftware.com/products/ ... Controller

[ add comment ] ( 1 view )   |  [ 0 trackbacks ]   |  permalink
Reverb Tank, MOD 4AB3C1B 
Replacement Reverb Tank for 4AB3C1B
Used In Fender, Marshall, And Ampeg Amps
Solid, Sturdy Construction
Long (16 ¾") 2 Spring Unit , Long Decay
Input Impedance 8 Ohms, Output Impedance 2250 Ohms

The MOD Reverb Tanks are high quality upgrade units. Some of the major differences between the MODs and other reverb tanks are that the Transducers are wired directly to their respective RCA jacks as opposed to current production tanks where Transducers are connected by a detachable plug to their respective RCA jacks. This makes the tanks less receptive to any outside interference. The original Hammond Accutronics tanks from the 1960s were also wired directly to their respective RCA jacks. In addition very close attention has been paid to the spacing and size of the lamination of the Transducers resulting in a more vintage like tone.

[ 7 comments ]   |  [ 0 trackbacks ]   |  permalink  |  related link
Geo Synthesizer app for iOS 


[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
msp430-frequencyCounter 
msp430-frequencyCounter

[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
Faster switch(case) with intrinsic _even_in_range() 

switch(__even_in_range(TD0IV,30))
{
case 0:
...



default:
_never_executed();



[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
Mecrimus-B 
Mecrimus-B is a bit-bang implementation of low-speed USB 1.1 for MSP430 microcontrollers.

This is experimental code, and it is under active development. Currently, it runs on a MSP430G2452 with a digital external clock source of 15 MHz or 18 MHz. With Mecrimus-B 0.4 support for MSP430F2012 with 32768 Hz crystal clocking is added and it implements an USB HID mouse.

[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link
12pcs ,2 Pole 6 Position PANEL PCB Wiring ROTARY SWITCH 2P6T i 
12pcs ,2 Pole 6 Position PANEL PCB Wiring ROTARY SWITCH 2P6T i

[ add comment ]   |  [ 0 trackbacks ]   |  permalink  |  related link

<<First <Back | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | Next> Last>>